Origin Lite

Origin Select & Lite

Installation Process

For precise installation requirements and to ensure compliance with project specific conditions, always refer to the approved shop drawings.

1. Install Drip Flashings

Depending on the project specifications, install the bottom drip flashings first, if necessary.

2. Install Extrusion Backpieces

Install the 2 piece J extrusion backpiece where needed.

Drill weep holes as need at the bottom.

3. Install Cut Start Extrusion

Install the cut start extrusion at any location where a panel will interface with an extrusion.

4. Field Cut & Install Panels

Field trim panels as needed to accommodate site conditions.

Begin installation at the bottom left corner of the assembly.

5. Field Drill Fastening Holes

Field drill fastening holes at top of panel if top fastening flange has been removed.

6. Install Extrusion Caps

Seat extrusion caps into place with a rubber mallet.

7. Install Overlapping Coping

Install coping keepers, splice plates, and coping cap. (*If applicable)